Choose the help your home needs.
Repiped the boiler and added a hands-free setup with autofill, new expansion tank, and backflow, then charged the system with glycol and replaced corroded venting as needed. Bled the zones, verified heat and controls, and wrapped up with a quick walkthrough.
Set a new Burnham X205 boiler on a concrete pad, reused the thermostat, and swapped in four zone valves, four pumps, four actuator manifolds, plus a new mixing valve with antifreeze added. Purged and tested the system, then did a quick walkthrough with the homeowner.
Installed a new 2-ton Carrier AC with matching coil, flushed the existing lineset, and reused the thermostat while keeping the humidifier. Built transitions from the 14″ furnace to a 17″ coil and 19″ plenum, ran the drain without a condensate pump, verified a 21° split, and wrapped up with a walkthrough.
3 jobs
Heating and cooling in Medicine Lake, MN
Medicine Lake uses Plymouth for heating and cooling permits. Its own city handles other site work. A clear plan keeps the unit and the yard in view.
Give MSP your street address and parcel city when booking. A Medicine Lake address and a home near the lake in Plymouth are different. That affects which local review path the job follows.
Plymouth handles Medicine Lake's heating and cooling permits. If you want to move an outdoor pad too, ask about that step. Mark the new spot on your plan before you choose the unit.
Medicine Lake has rules for road use and hauling. Tell us about a narrow drive or a tight spot to unload. Check which city reviews apply before you set a date for the new unit.
If your home has a boiler, describe which rooms each zone heats. If it has a furnace, point out the ducts. This helps us plan equipment access alongside the local site checks.
Book with your full address and any plan to move the outdoor unit. Mention work already planned for the drive, yard, or rooms around the equipment.
| SERVICE AREA
We were experiencing poor air flow on the air conditioning side of our HVAC system, throughout the house. .Jimmy was able to adjust the setting on the furnace motor. The air flow improved immediately. He also recommended we set the thermostat to “fan on” vs “auto” all the time. Jimmy was very friendly, knowledgeable and fast!
Jackson patiently walked me through the issue I was having with my air conditioning. Very knowledgeable and amiable. Update: Jefferson installed my new system. He did a wonderful job and was a delightful human on top of that.
Punctual, patient, friendly and respectful. We needed a new water heater, ours was shot. They got everything done in great time and cleaned up better than it was when they got here. Nick was a pleasure to work with, would recommend!
We’ve delivered unmatched customer service to the Twin Cities for over 100 years. You’re in good hands with MSP!
