Choose the help your home needs.
Swapped in a Carrier Performance 80% two-stage gas furnace (58TP0B070V17–16). 90% option was ruled out on site due to no code-compliant vent path; kept existing B-vent with chimney liner/cap. Reused thermostat, EAC, drop & boot; removed humidifier. Added GFCI outlet (by EC), ran 5-wire to stat, installed a condensate pump, temp-wired and test-fired—final electrical by Powerhouse. System operates properly.
Installed a Carrier condenser with matching cased coil via rooftop access, reused and flushed the lineset, and kept the existing thermostat, drop, and boot. Added 12 oz of refrigerant for the lineset, set airflow around 885 CFM, installed a condensate safety (“kill”) switch on the coil, and verified operation; charge left conservative due to ~50° outdoor temps.
Installed a 2-ton Carrier condenser with matching coil, reusing and flushing the existing lineset and keeping the current thermostat. Built a new transition from coil to canvas, left the homeowner’s clean filter in place, and started the system to confirm solid cooling.
3 jobs
Heating and cooling in Highland Park, MN
Highland Park is part of Saint Paul. Our work there shows why roof access, furnace vents, and the existing controls can matter as much as the equipment you choose.
MSP's Snelling Avenue South AC install used rooftop access. Tell us where every unit sits. A quote should plan the way in and out before the old system is taken apart.
At Montreal Avenue, a vent limit shaped the furnace choice. At West Highland Parkway, cooling work needed a duct transition. Each half of your system deserves its own fit check.
Several Highland Park jobs kept the existing thermostat. Tell us if you like yours or want a change. We can explain what fits the new system and what wiring would be needed.
The city lists Highland as District 15. Use the full Saint Paul address for past permits and planned work. That keeps the review tied to your home and the right city.
For an HVAC quote, tell us which unit needs help first. Include roof access, a tight utility room, or any known limit on the vent route.
| SERVICE AREA
Great company. Had an another company come to check my air conditioner and furnace. Was told needed to replace. Wanted another opinion and MSP said it was fine. So happy. The technician was great. Told friends about MSP.
MSP did such a great job in my A/C install I chose them to replace my heating boiler. Once again I got exceptional service from both Dave Johnson, the estimator and Jefferson Hanson, the installer. Jefferson was efficient, extremely knowledgeable and respectful of the workspace. I cannot recommend MSP enough.
Plumbing under sink needed to be replaced because the glued joints were leaking. Tom Miller did great work! We also had to have the drain line that runs underneath the basement slab cleaned and Donovan did an excellent job also despite having problems with some of the equipment. Overall I would use them again without hesitation.
We’ve delivered unmatched customer service to the Twin Cities for over 100 years. You’re in good hands with MSP!
